uc 100 problems

[cousinit75]

This is the Z controller pins configuration

[cousinit75]

And this is the X and Y controllers

[cousinit75]

The pin numbers for step and direction are different. If you haven't changed any wiring, set them to match what they were before.

Thank you "ger21" I now have both directions in X and Z . I have power to the motor and when I looked into the control box I can see the controller has power and is sending signal via a small green light that lights when a direction buttons pressed and the dros are moving . I hoping it's another setting I've just missed.

[cousinit75]

Hi I managed to successfully install and get working my mach3 and uc100 controller ( the one that converts from paralell to usb). But now im getting this error after upgrading my pc to windows 10 and tried to reinstall my legit license. Anyone else had this?

[cncdrive]

Make sure to enable the .net framework 3.5 in the Windows features.

[cousinit75]

Make sure to enable the .net framework 3.5 in the Windows features.

How exactly do I do that?

[cncdrive]

Google it please, it is a Windows thing, so you will find lots of answers.

[cousinit75]

Google it please, it is a Windows thing, so you will find lots of answers.

Then what?????????????

[cousinit75]

Google it please, it is a Windows thing, so you will find lots of answers.

Then what?????????????

Ok done that and it allowed me to select the controller. Now I have the issue that my estop wont reset and I have checked the physical button but it just won reset ??

[charliem]

Ok go into the uccnc software and goto configuration/I/OSetup.
Then look and the eStop and make sure you the correct pin and port selected. Also either active high or active low check box.