Manual Tool Change with Probing Screen

[CADdy]

Hi,

I also have the problem with the M6 macro hanging from time to time. I have found out that this occurs when soft limits are switched on and the Z-axis triggers this. If I turn off the softlimits in the settings, the macro runs through without a problem. However, the problem does not always occur.

Peter

[kjetil]

Hi
can anyone tell me how to set up this touch probe.

I have checked in diag that the lights come on when I press down the probe.
I have also copied the m6 macro from this thread and added it to the software. I have also changed so that the correct position is clear of the macro.

what do i do then?

[kjetil]

Hi good people

I have now run some tests with M6 macro and it works well.
How can I get the message about the name of the tool to be changed to.
I use vcarve pro and always name the toolpatch with the name of the tool.
Now I just get up that I have to switch to T2 for example.

Daniel collins gets exact name which tool to switch to ??

can i pay someone to tweek it ?