Hi all,
I tried to find an answer to this question but didn't.
As the Port#1 pins 2. to 8. of the AXBB-E ( isolated outputs) can drive up to 500mAmps of current up to 24Volts voltage levels, do you think I can directly drive pneumatic valves (24V, 200ma) without the use of intermediate relays?
Moreover, the manual is not clear : the 500ma is per output (so a maximum of 500x7 = 3000 ma) or the sum of the outputs as I might drive 3 solenoid valve at the same time ?
Many thanks for your feddaback !
AXBB-E and solenoids
4 posts
• Page 1 of 1
AXBB-E and solenoids
by nitro » Thu Apr 21, 2022 1:45 pm
- nitro
- Posts: 17
- Joined: Thu Apr 21, 2022 1:38 pm
Re: AXBB-E and solenoids
by Battwell » Sat Apr 23, 2022 10:31 am
i use the ucbb which i believe is the same output circuit.
i direct drive the air solenoids from the ucbb. no problems. i have up to 6 active at the same time in my setup.
i direct drive the air solenoids from the ucbb. no problems. i have up to 6 active at the same time in my setup.
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
- Battwell
- Posts: 867
- Joined: Sun Sep 25, 2016 7:39 pm
- Location: South Wales. Uk
Re: AXBB-E and solenoids
by nitro » Mon Apr 25, 2022 1:56 pm
Thanks for the feedback ! I can therefore drive directly my air solenoids ! no need of diode or anything to prevent back current or anything ?
- nitro
- Posts: 17
- Joined: Thu Apr 21, 2022 1:38 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 34 guests