UCCNC-300ETH UCBB_PROMA 150 Wiring-SETUP

[WildeFabrication]

Hello All,
Hopefully I can get some clarity on this Proma Installation. Lights are not showing on input from THC. No drive motion happening during Proma Test. With THC not Enabled I am able to move my Z Axis. More then likely something simple I missed and keep overlooking.

Current Setup consists of
Proma 150 Inputs:
300ETH 5LTP_UCBB CN2- Port 4
11+ THC Up
11- -24v -0 UCBB
12+ THC Dwn
12- -24v -0 UCBB
13+ THC ARC
13- -24v -0 UCBB

PROMA PSU Inputs-
24V+ to PSU 24V+
24V- to PSU 24V- 0
COMM to PSU 24V- 0

UCCNC- Z-AXIS UCBB CN1 Port 3
Step PIN- 14_Port 3
DIR PIN- 16_Port 3
Enable Pin- 17_Port 3

UCCNC I/O THC
ARC On Pin 13_Port 4 Active Low
THC UP PIN 11_Port 4 Active Low
THC DWN PIN 12_Port 4 Active Low

[WildeFabrication]

Got it figured out.. Reversed my 24V connections