Windows 10 computer, UC100 with C11G

[allonmorris]

When I first start up the machine the UCR201 works fine, I use it to set up whatever I will be working on. After I run a program it loses connection and will not connect again until I do a computer restart.

Any ideas, it is getting very annoying? Windows 10 computer, UC100 with C11G.

Thank you for any help

[cncdrive]

What if you just unplug and replug the USB transmitter of your UCR201 does it recover then?
And it is probably noise effecting your computer and so your USB port, so try to filter out that noise on the mains to your computer.