RUN and JOG Stay On After Homing

[FactoryWorks]

a few more things I have found. In searching this issue I came across a person who said they had the exact problem and once they unchecked the box for slaving A to Y (as they were not using a slave axis anyway) this problem went away. I tried it the same way, and verified it DOES fix the problem, however of course I need my slave stepper. I also found that after homing, if I move to 0,0 via the mdi there is no event- however once I jog it with the keyboard the event occurs again. This is easily replicatable and seems to be troubling a few people, not sure why it was so quickly ignored.

[DavidR8]

Is there any update on this issue @cncdrive

[cncdrive]

Dezsoe, Please test this bug report.

[FactoryWorks]

here is my .pro

[dezsoe]

The bug exists using UC100, but not with UC400ETH. I tested with 1.2113 and 1.2116.

[dezsoe]

I did some more tests. The problem exists with UC300 USB too, so it's related to the USB devices. Also, I found that the bug appears only if there is a homing backoff on the slave axis.

[johnsattuk]

The bug exists using UC100, but not with UC400ETH. I tested with 1.2113 and 1.2116.

1.2116
Can't find it

[FactoryWorks]

Dezsoe, thank you for looking into this! As a workaround I set both my Y and A to 0 back off and it’s working great! I’m sure it will get figured out but the workaround is perfect for me.

[dezsoe]

The bug exists using UC100, but not with UC400ETH. I tested with 1.2113 and 1.2116.

1.2116
Can't find it

Yes, because it hasn't been released yet.

[Gebbi]

I did some more tests. The problem exists with UC300 USB too, so it's related to the USB devices. Also, I found that the bug appears only if there is a homing backoff on the slave axis.

Hi dezsoe,
thanks for that information.
I set back off to "0" --> there is no more problem
I was no aware that there is a (very) small back off (allthoigh the value is "0") to get out of the end switch.