Below you can see that UCCNC cuts beautiful circles no jagged edges.
Jagged Arcs/Circles
13 posts
• Page 2 of 2 • 1, 2
Re: Jagged Arcs/Circles
by formantjim » Thu Mar 03, 2022 8:02 pm
Hi Tedris just ran your code on my DIY machine using UCCNC and ETH300 and it performed beautifully no jagged edges whatsoever so I'm sorry to say it must be a mechanical issue at your end. It has nothing to do with ARCs etc.
Below you can see that UCCNC cuts beautiful circles no jagged edges.
Below you can see that UCCNC cuts beautiful circles no jagged edges.
- formantjim
- Posts: 76
- Joined: Fri May 31, 2019 5:28 pm
Re: Jagged Arcs/Circles
by tedris » Thu Mar 10, 2022 5:41 am
Sorry that i didnt respond so far. I got a bit sick and need to recover.
After that i need to check everything on the mechanical side and will report back if i find anything.
After that i need to check everything on the mechanical side and will report back if i find anything.
- tedris
- Posts: 6
- Joined: Wed Mar 02, 2022 10:32 am
Re: Jagged Arcs/Circles
by formantjim » Thu Mar 10, 2022 8:10 pm
No worries glad you have recovered. You might want to check your power supply to the servos because as you say when cutting linear moves it is fine but when both axes are running then trouble happens. Just a thought.
- formantjim
- Posts: 76
- Joined: Fri May 31, 2019 5:28 pm
13 posts
• Page 2 of 2 • 1, 2
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 47 guests