When opening the file, the wrong G-Code recognition is observed
I apply 2 screen - from the UCCNC window and from CIMCO, and the file TAP.
Error trajectory
3 posts
• Page 1 of 1
Error trajectory
by fixebr » Tue Mar 01, 2022 1:25 pm
- Attachments
-
1 - 11 скругление.TAP- (74.23 KiB) Downloaded 254 times
-
-
My English is bad, so you're reading machine translation results. Alas.
-
fixebr - Posts: 40
- Joined: Thu Dec 30, 2021 8:30 pm
- Location: Russia, Moscow
Re: Error trajectory
by cncdrive » Tue Mar 01, 2022 5:10 pm
Your g-code has problems. Arcs in the code has different start and end radius which basically makes your arcs invalid.
However the UCCNC handles these cases, but your code still not good.
Mach3 do not even run your g-code file.
However the UCCNC handles these cases, but your code still not good.
Mach3 do not even run your g-code file.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Error trajectory
by fixebr » Tue Mar 01, 2022 5:45 pm
This code is generated in SolidCam, on a standard (basic) postprocessor. While the problem decided, replacing the arcs with the G17 etc on the G00.
But it seems strange to me that the standard code is not recognized by the program. Maybe there are some settings of the machine file so that such an error does not occur?
But it seems strange to me that the standard code is not recognized by the program. Maybe there are some settings of the machine file so that such an error does not occur?
My English is bad, so you're reading machine translation results. Alas.
-
fixebr - Posts: 40
- Joined: Thu Dec 30, 2021 8:30 pm
- Location: Russia, Moscow
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests