Error setting AXXBE and Huanyang HY03D023b

[macpoy26]

Hello
I debute with UCCNC
I have a settings problem on the 0-10V command.
Here are the UCCNC configuration screens:

Here are the parameters of the VFD:
P3 : 400
P4 : 400
P5 : 400
P11 : 100
P72 : 400
P73 : 100
P144 : 3000

Here are the analog values identified:

relevé vitesse.JPG (28.67 KiB) Viewed 4787 times

What is the parameter that is not good?
Thank you for your help
Claude

[ger21]

Try PWM Min Duty at 25%

[macpoy26]

Try PWM Min Duty at 25%

Hello
Thanks for your help
I tried to play with this parameter.
Here is the result 25%

relevé vitesse 2.JPG (21.27 KiB) Viewed 4779 times

Do you have another idea?

[macpoy26]

I continued to look for where the problem comes from.
I made tension measurements on the AO1 exit.

relevé tension vitesse.JPG (17 KiB) Viewed 4737 times

As it seemed to me that the card did not deliver more than 5V to 100%, I repositioned the strap on the choice exit 0-5V.
And the it works !!!!!

relevé tension vitesse avec cavalier 2.JPG (24.92 KiB) Viewed 4737 times

I have an analog value up to 10V

But I do not understand why?