Ask for homing after kill switch

[Blaise]

I have setup my Kill switch to trigger the error line of the drives.
Once the kill switch is released, the drives are reset.

I would like UCCNC to ask for the machine to be homed before Cycle start can be pressed. Or a tool change can be called. Also any move using MDI. Any motion other than jog.

Any suggestion on how to go about doing this?

Thanks!

- Blaise

[cseyler]

In general settings
-> check mandatory homing and also reset deref home

[Blaise]

Thanks! That helped a lot.

Is there a way to Derek home via a macro?

[ger21]

Try:
exec.Callbutton(781);

[Blaise]

Yes!!!

exec.Callbutton(781); worked a charm!

Where did you find this information? I am curious.

Thanks!

- Blaise

[ger21]

UCCNC\Documentation\Buttons_by_Number

[Blaise]

Oh! I had an older version that did not describe buttons over 777.
Buttons from 778 to 999 were described as « reserved »

I found the latest version. Il have some reading to do!

Thanks!

[cseyler]

All the information about buttons, leds and fields are present in your UCCNC directory (default : c:\UCCNC\documentation)

[marteng]

All the information about buttons, leds and fields are present in your UCCNC directory (default : c:\UCCNC\documentation)

I thought I saw them somewhere, thanks for reminding me that they were under my nose.
Marteng