internal variables

[leon150ts]

hi, maybe it's a stupid question, but where can I find the list of internal variables?

[ger21]

I think this has been asked several times over the years, and it's never been answered, other than the few listed in the manual for probing.
A lot of people would like to see a full list.

[dezsoe]

I don't know about any special variable that is not in the manual. All others are free to use.

[Robertspark]

there are only 7 defined variables in uccnc (1 for each axis and 1 for a successful probing routine). They are located in the user manual (and my macro manual on the link below).

[Vmax549]

Long ago I did a search of all possible Vars up to about 100000 and there were ONLY 7 as Robert said 6 axis probe positions and a probe verify touch.

I don't remember what the max possible was. Normally I would input values into a range of vars up to what ever and then do a search of those ranges.

Just a thought, (;-) TP