forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

AXBB Port 3

If you have a question about the software please ask it here.
Post a reply

AXBB Port 3

Postby johnsattuk » Thu Aug 19, 2021 12:26 pm

Is it OK to use ports for step/dir/enable outputs
johnsattuk
 
Posts: 79
Joined: Thu Aug 12, 2021 1:24 pm
Top

Re: AXBB Port 3

Postby cncdrive » Thu Aug 19, 2021 1:41 pm

Yes.
cncdrive
Site Admin
 
Posts: 4887
Joined: Tue Aug 12, 2014 11:17 pm
Top

Re: AXBB Port 3

Postby johnsattuk » Thu Aug 19, 2021 2:08 pm

Thanks :D
johnsattuk
 
Posts: 79
Joined: Thu Aug 12, 2021 1:24 pm
Top
Post a reply

Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 58 guests

Powered by phpBB® Forum Software © phpBB Group