If I get ucnc software and the axbbe controller, will I be able to connect to the Huanyang Hy02d223b vfd?
If so, will I able to control spindle speed from ucnc?
Huanyang Hy02d223b vfd
4 posts
• Page 1 of 1
Huanyang Hy02d223b vfd
by zapbrannigan » Tue Aug 10, 2021 6:40 pm
- zapbrannigan
- Posts: 17
- Joined: Mon Aug 09, 2021 6:21 am
Re: Huanyang Hy02d223b vfd
by cncdrive » Tue Aug 10, 2021 6:42 pm
If the VFD has an analog input (0-5V or 0-10V) for speed reference then yes you can control it with the AXBB-E and UCCNC.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Huanyang Hy02d223b vfd
by zapbrannigan » Sun Aug 15, 2021 1:19 pm
In order to control spindle speed, is the following wiring sequence correct?
VFD and FOR are connected through a normally open 24V relay (output 2 on AXBB-E - Port 1 pin 2).
A01 goes to V1
ACM goes to 5V0 (Power out portion on the AXBB-E)
VFD and FOR are connected through a normally open 24V relay (output 2 on AXBB-E - Port 1 pin 2).
A01 goes to V1
ACM goes to 5V0 (Power out portion on the AXBB-E)
- zapbrannigan
- Posts: 17
- Joined: Mon Aug 09, 2021 6:21 am
4 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Bing [Bot] and 24 guests