Floating Head Confusion

[alanmccabe]

HI all, I am new to this forum and new to plasma cutting, currently I am building a 4x4 machine using UC300eth and UCCNC software. I have a floating head and cannot figure out how to get it to work.

This is what I am doing
Using sheetcam and the UNCC Plasma post processor I am exporting my file.
I have enabled M31 macro on UNCNC

I am not sure where in the macro to add my switch offset of 5.47

when I try to run the file I get the error The machine has not been homed home the machine before run to parking position.

Any help would be appreciated.
Many Thanks Alan

[Robertspark]

Dont cross post: viewtopic.php?f=16&t=3310&p=24418#p24414