Question about CAM module built into UCCNC

[The-Meerkat]

I've never seen any operating instructions for the CAM tab in UCCNC. I have not seen any posts here either. I'm wondering if anyone uses it? How is it? Where can I find info?

[cncdrive]

It is in the UCCNC/Documentation folder of your installation.
All documentation is there.

[The-Meerkat]

I didn’t know about the documentation folder. It looks like there is some good reading for me there. It’ll probably answer a lot of my dumb questions. I’m excited about that.

Thanks.