UCBB wiring Help

[Demosd]

Hi all,
New to this forum but have had a good browse with lots of insight.
I am waiting for delivery this week hopefully of UC300ETH-5LPT + UCBB breakout board.
I have looked through the manuals and tried to figure out the wiring for the UCBB with my limited knowledge of wiring diagrams.
I have attached a simplified diagram in the hope I can get some feedback, if I am on the correct path so that I am ready to install as soon as the BoB arrives.
Any help would be greatly appreciated.

[cncdrive]

Your wirings all look good.

[Demosd]

Thanks for the reply. Good to be reassured of my initial thoughts.
The only thing I forgot was the probe, but I assume it is wired like the Estop.