Application crash on MDI input

[johu]

UCCNC version 1.2112 crashes when entering in the MDI:

Code: Select all

N20910

And also with:

Code: Select all

N1

I know the above code is wrong, i.e. it should have been M20910 and M1.
But the application should not crash without a warning or without an unhandled exception.
It should emit a warning that the input was invalid.

[dezsoe]

Ooops! The same with 1.2113...

[cncdrive]

OK, I'll check it.

[cncdrive]

OK, I found the reason for the problem and fixed it.