Hello Balasz,
Mach 3 r. 1.043.66, UC300ETH5LPT, probe input 4/10.
I need to use the probe to check position of piece to work.
G91G31Z-20F100 (It is suppose not to trigger at this point, this is only approach)
The axis move but when the quote is achieved then it stops. Only if I hit the probe then it executesto the next operation.
I have same application but wit UC300USB and works perfectly.
Pugin 1.006 (tried right now 1.007 found on the forum but same problem).
Pls help
Alberto FUL
G31 Mach3
5 posts
• Page 1 of 1
G31 Mach3
by Alberto FUL » Thu Jan 12, 2017 2:00 pm
- Alberto FUL
- Posts: 39
- Joined: Thu Jan 12, 2017 1:48 pm
- Location: Italy
Re: G31 Mach3
by ger21 » Thu Jan 12, 2017 3:16 pm
Try Mach3 3.043.062.
Version .066 has issues with probing with other motion controllers.
Version .066 has issues with probing with other motion controllers.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: G31 Mach3
by Alberto FUL » Thu Jan 12, 2017 4:22 pm
Gerry,
Same behavior with 3.043.62.
It seems that it has to hit something anyway. It Waits until the probe input goes on.
Same behavior with 3.043.62.
It seems that it has to hit something anyway. It Waits until the probe input goes on.
- Alberto FUL
- Posts: 39
- Joined: Thu Jan 12, 2017 1:48 pm
- Location: Italy
Re: G31 Mach3
by Alberto FUL » Thu Jan 12, 2017 4:24 pm
UC300USB has no problem with 3.043.066
Neither UCCNC has problem with G31
Neither UCCNC has problem with G31
- Alberto FUL
- Posts: 39
- Joined: Thu Jan 12, 2017 1:48 pm
- Location: Italy
Re: G31 Mach3
by cncdrive » Thu Jan 12, 2017 9:24 pm
This was fixed and test plugin posted in the duplicated thread: viewtopic.php?f=3&t=367
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests