WHB04B-4 Pendant Plugin

[jpmreno1966]

I cant get my pendant to do anything. I have the WHB04B-4 and it says the signal is there, but its not doing anything.

[jpmreno1966]

What is the process of loading this new plug in and using the pendant. I have one and would like to use it.

[Reiziger]

Hi Andrew,

can I use your plugin with the LHB04B-4 pendant (wired version of the WHB04B-4 pendant)?

Regards

[Reiziger]

Hi Andrew,

can I use the wired version of the WHB04B-4 pendant (LHB04B-4) with your plugin?

Best regards,

Luc

[Lasaarkam]

What is the process of loading this new plug in and using the pendant. I have one and would like to use it.

That was quite simple after all. I have ABXX-E with UCCNC 1.2111 running on 64-bit Win 10.
1. downloaded the first WHB04BPendant.rar on this thread, extracted the WHB04BPendant.dll
2. copied the WHB04BPendant.dll to my UCCNC/Plugins directory (in my case, C:\UCCNC\Plugins)
3. launched UCCNC, and at configuration tab -> general settings -> configure plugins, looked for WHB0B-4_pendant and checked the Enabled box
4. closed the UCCNC, and relaunched it; plugged the bluetooth receiver of the pendant into USB, and turned the pendant on
5. voila, it started to work (with the limitations explained in this thread)
Must say, that it didn't work at first for some reason, but basically that was the train of actions I took to get it working.

- Lasse

[Mr.Hotwire]

When I install the plugin, It tells me "Tere are no settings".

Am I doing something wrong? This is a 6-axis pendant by the way.

[rmorr01]

Works Perfect, Thank you! : )

[someworkshop]

When I install the plugin, It tells me "Tere are no settings".

Am I doing something wrong? This is a 6-axis pendant by the way.

I had the same problem. I redownloaded the .rar on the first page of this post and it worked. The .dll file was a few months older than the one I had for some reason.

[Electriflyer]

Hello!
For those who want to test out the WHB04B-4 pendant plugin.
Please let me know if there is a bug's.

Works perfectly for me. Thanks heaps.

[nick_p]

Hi all, I've been using UCCNC for 1 year now and all is great. I just bought the WHB04B 4 axis version from Amazon and I can't get it to work. I've read through this entire thread a couple of times. I tried the download in the first post, and also 2 other downloads scattered throughout the thread. All have the same issue. It says "MPG not connected". I'm using UCCNC 1.2112 with the simple 4 axis screenset from the UC100 facebook group. Has anyone else had this error? Does anyone know the solution? Could the 1.2112 version be the issue? Could the screenset be the issue? I'd rather not reinstall everything (unless the version is definitely the issue) as my machine is running great. Screenshots below. Thanks!