Return to part zero after cut

[Skrotskalle]

The problem is that it returns to home position/machine zero after the cut.
The M25100 macro should not be there, I had that macro on my previous setup before I changed to Neuron Lite. But it should not any effect on this problem. I will turn it off anyway.
I work abroard and have my plasma table in my shop back home and as I am now back on work now, I do not have access to it right now. And with this covid crap I do not know when I will be back, so it will be some time before I can do any more troubleshooting/testing. But I will increasing the microstepping a bit.
I will email you when I am back home again.

[Blackslacks]

Sheetcam - Options - Job Options - Parking