forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

G89 cycle problem...

If you think you've found a bug post it here.
Post a reply

G89 cycle problem...

Postby hmnijp » Mon Feb 15, 2021 5:25 pm

Hello! I am writing a post-processor, and while checking canned cycles I noticed that G89 does not drill in coordinates after the first line ...
Version 1.2111 and 1.2113.
G89 cycle.jpg
hmnijp
 
Posts: 44
Joined: Sun Jan 17, 2021 12:59 am
Top

Re: G89 cycle problem...

Postby dezsoe » Mon Feb 15, 2021 7:55 pm

Thank you, I've put it on the list.
dezsoe
 
Posts: 2093
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary
Top
Post a reply

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 6 guests

Powered by phpBB® Forum Software © phpBB Group
cron