Unexplained moves: I do MDI G0 Y move but X&Z also move

[Zed_UCCNC]

I have an unexplained X and Z move when I do an MDI command.
When I do G0 Y0.003 (NO X or Z!) the DRO shows an X and Z move ( and the Z axis actually moves)
And even though the command is to go to where the axis actually is, Y moves.

Is there a setting I should change or something else I should do?
Please see the video linked below.



https://photos.app.goo.gl/v9WUjKvRywMmA7Rx6

[Zed_UCCNC]

In this video when I do G0X0Y0 when X=0 and Y=0, the Z moves.
The Z shouldn't move.
Deszoe or Cncdrive, can you tell me if there is a setting I should change?
https://photos.app.goo.gl/n6MCWuHPRHmux28K9

[Zed_UCCNC]

deszoe or cncdrive, could one of you take a look at the short video and tell me if there is something I can do to not have the unexplained Z move?