Issues With UCCNC software

[charliem]

Hi Gerry Thanks I will try what you suggested and post back. Thanks.

CNCDRIVE,

Thanks for the reply. I will look at the info and hopefully I can learn something.

[charliem]

Hello Everyone,

So I learned a few things. First my jerky movements were associated with the feed rate. I slowed down the feed rate and it smoothed things out a bit. I loaded another Gcode file and all the jerkyness went away. I then set the feed rate back to 100% everything works as expected. It seems that the first gcode file I was messing with has a lot of short segments. I can post the offending file if anyone wants to confirm this.

Also I played with the Min Pwm settings and I have my spindle speed close enough.

Thanks to everyone who helped me on this.