wiring axbb-e with Proma THC 150

[cncrail]

Hello everyone . I just bought AXBB-E, I would like to have the wiring diagram between this and the THC 150 from Proma which is in my possession.. Grazie

Antonino Bortiglio

[cncrail]

software : UCCNC CNCDRIVE control software for USB and ETH controls

Valid alternative to Mach3, the software works only together with the usb or ethernet controls UC100, UC300, UC300ETH, UC400ETH, AXBB-E, natively supports the THC of Proma, imports the mach3 configuration files (profiles) i bought for this reason!!!

[cncdrive]

The proma THC150 outputs 3 signals, ArcOK, THCup and THCdown.
You can connect the signals to any inputs of the AXBB-E, then you just have to configure these functions to the inputs as per your connections.

[cncrail]

hello thanks for the answer can i configure with mach3?

[cncdrive]

Yes, it works with mach3 too.

[cncrail]

ma posso portare la stessa configurazione in UCCNC dal mach3