Moving to UCCNC from Mach 3
13 posts
• Page 2 of 2 • 1, 2
Re: Moving to UCCNC from Mach 3
by Robertspark » Wed Dec 30, 2020 4:50 pm
Sorry, out of ideas, looked at the Mach3 profile + UCCNC one and nothing jumped out at me.
UCCNC Macro Manual v1.2113 - https://drive.google.com/drive/folders/ ... sp=sharing
- Robertspark
- Posts: 1892
- Joined: Sat Sep 03, 2016 4:27 pm
Re: Moving to UCCNC from Mach 3
by waukeenahBob » Wed Dec 30, 2020 4:57 pm
could it be the license file... since the inputs work and I can hear the motors engaging it doesn't seem likely but I am out of ideas too
- waukeenahBob
- Posts: 8
- Joined: Tue Dec 29, 2020 1:35 pm
Re: Moving to UCCNC from Mach 3
by waukeenahBob » Wed Dec 30, 2020 6:12 pm
FOUND IT!
The enable pin and port did not make it over from Mach3.
Thanks for all the help!
The enable pin and port did not make it over from Mach3.
Thanks for all the help!
- waukeenahBob
- Posts: 8
- Joined: Tue Dec 29, 2020 1:35 pm
13 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 16 guests