Check teh setting for :
M3 dwell after off
dwell = MS or sec
Just a thought, (;-) TP
Laser Question
14 posts
• Page 2 of 2 • 1, 2
Re: Laser Question
by Vmax549 » Sat Nov 21, 2020 5:26 pm
- Vmax549
- Posts: 331
- Joined: Sun Nov 22, 2015 3:25 am
- Location: USA
Re: Laser Question
by naijin » Sun Nov 22, 2020 3:17 am
Default.pro- my current profile
- (35.83 KiB) Downloaded 395 times
- naijin
- Posts: 106
- Joined: Mon Dec 04, 2017 11:24 pm
Re: Laser Question
by dezsoe » Sun Nov 22, 2020 9:17 am
Hi Nick,
As I thought, the M3 settings are joking you.
You have the spindle PWM on the same pin as the laser. Set the spindle PWM output to port 0, pin 0.
Also, the output triggers are strange on pin 2 and 3.
As I thought, the M3 settings are joking you.
You have the spindle PWM on the same pin as the laser. Set the spindle PWM output to port 0, pin 0.
Also, the output triggers are strange on pin 2 and 3.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
Re: Laser Question
by naijin » Sun Nov 22, 2020 10:50 pm
Dezsoe.. Your are a Legend!! A super Hero, thanks you for your help.. every thing is working fine now. 
Cheers Nick
Cheers Nick
- naijin
- Posts: 106
- Joined: Mon Dec 04, 2017 11:24 pm
14 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 18 guests