Relay connection help on ucbb

[patgabatch]

ok, the pump will be on when the spindle turns, but what do you mean by "set an output trigger on the relay and spindle to LED (50, pin CW)." I admit that I don't understand, is this where I have to configure my pump?

[patgabatch]

Hello again, after some research, I ended up finding, by setting the output trigger I understood the principle, and by activating the launch button of the spindle, my relay is activated.
thank you for this very precious help,
cordially
Patrick

[dezsoe]

Fine!

[patgabatch]

hello, I have a relay block in 24 volts, can I use to replace the 5volts, if I supply GND and VCC 0v / 24v and that I connect IN1 to output Ox
cordially