WHB04B-4 Pendant Plugin

[brandonwong]

Thank you so much for this.

I’m using a newly purchased wireless 6-axis and couldn’t get it to work on the stock plugin.
I gave up and while having supper found this thread. I fired up in demo mode and reconnected the pendant and I’m off to lalaland!!!

Yippie yay!

Brandon

[joey81]

My WHB04B-6 arrived an hour ago.

It works!

Still learning the ropes, but the plugin is functional enough for my work.

Thank you so much, Shad!

[trikkas.a]

Hello, I'm thinkink to buy this jog. What keys dont work with the last plugin. Thank you

[pmorton]

I am new to this forum, so please excuse me if I am repeating others' questions.
I downloaded and put the .dll into the UCCNC folder but the software doesn't seem to be picking it.
I keep getting the "Receiver Not Connected" message
any help would be helpful.
I am using UCCNC 1.2049 (so it's not the latest) with UC300eth board. I was using the UCR201 but that won't connect either
it is quite possible I am doing something stupid as I am still somewhat new to the CNC world.
thanks
Paul

[asuratman]

Do you guys think It is better to purchase 6 axis pendant than 4 axis one since 6 axis work for all ?

[thegreatwaldo]

Paul
Try plugging the transmitter into another usb port and maybe using the the current official release version or the latest test version.
Cheers
Andrew

[Delco]

Is it possible to get the macro buttons and function buttons working on the plugin ?

[shad]

Hello!
There are 10 buttons for UCCNC functions and macro.
Try to check connection of the receiver.
Plugin must be copied to the Plugins folder and enabled in the "plugins" settings of the UCCNC.

[thegreatwaldo]

Paul
Try plugging the transmitter into another usb port and maybe using the the current official release version or the latest test version.
I meant to say reciever!! Not transmitter.
Cheers.
Andrew
Cheers
Andrew

[Delco]

Checked all the functions on the wired WHB04B pendant and they all work as expected , the only thing I have been unable to work out is how to get the macro buttons setup ? on the earlier plugin there was a setup configuration page , on this new plugin there is not that option that I have found ??? Anyone know how to get it to work ?