HB04 pendant

[drumsticksplinter]

Would this likely be a bug with using the AXBB controller, or something I am doing wrong in my setup? Thanks

[drumsticksplinter]

Just wondering if anyone is able to look into this from cncdrive please? Is it just my pendant or would this functionality be the same with any pendant using AXBB? Thanks

[cncdrive]

Dezsoe,

Please test this... thanks.

[andreiir]

If i select a axis , and use mpg count , if i rotate encoder wheel , and move the rotary switch to another position , then it doesnt stop from counting and axis go until softlimits are reached or i press cicle stop or reset , or i switch the roatary again on axis that i was before .
On mach 3 it doesnt make this bug , only on uccnc plugin .

[drumsticksplinter]

Hi, it’s been a little while, did this ever get looked into by cncdrive? Would the UCR201 pendant work with the axbb-e without having the bug I’m experiencing, or is it just my mpg? Thanks.

[andreiir]

I agree , if i put a value , it goes totaly wrong , it doesnt make steps like mach3 , it goes more steps than it shuold .
And if i save the value , next time i open the soft , it resets , and goes to 5 .