LED 268

[laki]

Can someone check, please?
UCCNC ver 2113, default 2019 screen set.
On the main screen, the Led 268 (Softlimit active) remains on if you use more than 3 basic axes (x, y, z) and if the enable soft limits field is checked. The soft limits function itself works properly, but the LED 268 is always on.
On my machine, the B axis is configured as a slave for the X axis and the LED 268 is constantly on, even though the machine is not even close to the set soft limits.

[cncdrive]

Dezsoe,

Please verify if this problem exists.

[dezsoe]

Hi guys, I could not reproduce the issue. (I tried with demo and real AXBB-E, B slaved to X.)

[laki]

Hi Dezsoe,
Upravo sam probao AXBB, demo mode
Molim te pogledaj snimak
[youtube<iframe width="1280" height="720" src="https://www.youtube.com/embed/iTYa2FatwBU" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>][/youtube]

[laki]

Sorry,
https://www.youtube.com/watch?v=iTYa2FatwBU

[dezsoe]

OK, I got it. If the soft limit is the same as the home position and you set a slave then it will set the LED on.

[laki]

You can set the soft limit to any value, it does not have to be the same as the home position. If you turn on the slave axis, the LED 268 will remain on.