forum.cncdrive.com

by **Battwell** » Mon May 11, 2020 4:22 pm

reported via uccnc users group on facebook.
m30 doesnt run any added additional code if run from gcode?
but does from mdi

by **dezsoe** » Mon May 11, 2020 5:18 pm

There was a fix in 1.2110 for this problem. However, in 1.2113 it does not run.

by **Battwell** » Mon May 11, 2020 6:11 pm

i think its bad in version 112 as well

by **dezsoe** » Mon May 11, 2020 10:05 pm

Well, it works only till 1.2103. I don't understand: it was said to be fixed in 2110, but now I tested all 21xx versions and found it not working from 1.2104. Before release, when we have the full list of changes, I always check all the fixes or new functions, but this went through somehow. :shock:

by **Battwell** » Wed May 13, 2020 10:13 am

fix it again then :-)

by **cncdrive** » Wed May 13, 2020 9:33 pm

Yes, I'll check and fix it.

by **vitber** » Fri Oct 30, 2020 9:07 am

In version 1.2113 Macro M30 from the GCode does not work.
Please fix this. Is very important.
I have to enter my macro (m20030) by hand in each Gcode before M30.

forum.cncdrive.com

m30 doesnt run additional code

m30 doesnt run additional code

Re: m30 doesnt run additional code

Re: m30 doesnt run additional code

Re: m30 doesnt run additional code

Re: m30 doesnt run additional code

Re: m30 doesnt run additional code

Re: m30 doesnt run additional code

Who is online