Running UCCNC MouseLess ( Keyboard only)

[ger21]

standard keyboard F1-F12 has an easy 60 combinations for Fkeys

But right now, we're limited to a total of 48 hotkeys, unless there's something I'm not aware of.

[cncdrive]

Yes, there are currently 48 hotkeys "only".
We can extend these though if it will be required.

[ger21]

For those that are interested in running mouseless I created a Load Gcode function macro that loads a list of the gcodes in a specific folder and allows you to select a file and load it.

Would you mind sharing that?
While it may be a few years down the road, I may at some point want to do something like this.
But more importantly, I'd just like to see an example of these macros that run in their own windows.