Uccnc spindle setup

[Battwell]

does analog voltage change with different speeds commanded. ie s 1000 to s 5000? enter in mdi to test

[Stock3000gt]

No analog voltage doesn't change no matter what I set the speed at.

My settings are as follows.
Spindle page
PWM Freq-1000
PWM min duty- 0
PWM Max-100
M3 relay pin 2 port 1
spindle velocity min-18000
spindle velocity max- 24000
both pwn spindle and spindle relay output enabled are checked.
I/O setup page
only thing I have done is Spindle PWM -> analog ch. 1

[dezsoe]

Please, upload your profile (.pro) file to check.

[Battwell]

Uc 100 doesn't have an analog channel so untick that.

[dezsoe]

What kind of UC100? It is AXBB-E. At least on the first photo.
(And if it was a UC100 then there won't be an option to seledt analog channel.)

[Stock3000gt]

It's a axbb-e. How do I pull the pro file

[dezsoe]

Under the message box you find Upload attachment, press browse, select the .pro file, press Add the file.

[Stock3000gt]

Is this pro file gotten from uccnc and were do I find it in uccnc. Never herd of a pro type file before.

[dezsoe]

Yes, it is in the UCCNC\Profiles folder.

[Stock3000gt]

I will try when I get off work. Thank you so far for the help.