Autoleveler Plugin.

[VSievert]

Cahit,
I have been using Autoleveller with UCCNC the past few months and absolutely love it. I too am using a setup that is imperial and am looking forward to your next release.
Thanks for all the effort.
Vince

[cahit]

Hi VSievert,

i have a not functional version with very flexible settings ready. please take a look for it and let me know is this is ok for you and others.
any sugestions are welcome.

note: this is version 3

regards...

[VSievert]

Thanks Cahit,
I will give it a try and let you know how it works,

Thanks again,
Vince

[cahit]

Hello people,

here an update of development new autoleveler.

cheers

[submustang]

Cahit,
I finally got a chance to checkout test version 3, but can't seem to get it to load. I am running UCCNC V1.2049, is the test version compatible with the version I am running?

Thanks,
Vince

[Demusman]

Can anyone tell me the point of an this autolevel??
I get it for 3d printers but not for mills.
You get the work piece to be level with the Z axis, SO???, the bit will still be 'unlevel'.
What good is that?

[dezsoe]

Most people use it for PCB milling. See: https://github.com/Daedelus1982/AutoLeveller

[submustang]

Cahit,
I updated to UCCNC V1.2111 and loaded the test version 3 you recently made available. After installing autoleveler test version 3 and enabling the plugin I am getting the following error message

"Unhandled exception has occurred in your application. If you click Continue, the application will ignore this error and attempt to continue. If you click Quit, the application will close immediately.

Exception of type 'System.OutOfMemoryException' was thrown"

If I choose to continue I just get a blank screen.

Thanks
Vince

[submustang]

Can anyone tell me the point of an this autolevel??
I get it for 3d printers but not for mills.
You get the work piece to be level with the Z axis, SO???, the bit will still be 'unlevel'.
What good is that?

I use auto leveler to map surfaces that are not level, then apply a tool path and carve. There are many instances where surfacing the material is not desired.

[Demusman]

Can anyone tell me the point of an this autolevel??
I get it for 3d printers but not for mills.
You get the work piece to be level with the Z axis, SO???, the bit will still be 'unlevel'.
What good is that?

I use auto leveler to map surfaces that are not level, then apply a tool path and carve. There are many instances where surfacing the material is not desired.

This is my point, complete waste of time. If you're talking abaout 3d carving, There's absolutely no need to surface the material as the carve will be below the top anyway.

Most people use it for PCB milling. See: https://github.com/Daedelus1982/AutoLeveller

That's a perfect use of this. It's been a while since I've dona any PCB's but I will definitely try it next time I do.
Thanks!