forum.cncdrive.com

by **Battwell** » Sat Aug 10, 2019 12:03 pm

looking to make up a 5 axis b&c axis head for my router.
with current status of rotary now in uccnc is this likely to work with code from fusion 360?

by **Battwell** » Sun Aug 11, 2019 11:04 am

by **Mallemann** » Sun Jan 05, 2020 6:02 pm

I did build a 5 Axis table/table extension for my router. See details here https://www.masdrive.ch/myprojects/?page_id=572

by **NikolayUA24** » Mon Jan 06, 2020 9:29 am

Theme 5 axes. I ask here, UC controllers support RTCP ( Real-Time Transport Control Protocol)

by **NikolayUA24** » Mon Jan 06, 2020 10:21 am

Mallemann wrote:I did build a 5 Axis table/table extension for my router. See details here https://www.masdrive.ch/myprojects/?page_id=572

And how will you choose backlash in gear reducers.

by **NikolayUA24** » Mon Jan 06, 2020 12:12 pm

UC controllers support RTCP ( (Rotary Tool Control Point - control the position of the tool tip)

5 axis head with uccnc and fusion 360?