Help wiring THC

[Spoolnms]

Im sorry but I do not see that as an option under the Post processors? Or am I missing something?

[Vmax549]

Try updating your SheetCam version.

The post you are trying probably does not do arcs it converts everything over to lines.

(;-) TP

[Spoolnms]

Using 6.0.30, no updates available :/

Edit: Ah found it, its on the development version. . .

[Spoolnms]

Well, used the UCCNC post, and itll reference twice, then go up like 8" then come down like 1" and start the cut, nowhere near the work piece :/.

--************************************************
--*** Set these values up to suit your machine ***
--************************************************

--this is the distance between each torch reference in MILLIMETRES
refDistance = 500


--Scriber X,Y,Z offsets in MILLIMETRES. Do not use inches here even if you want inch code
--Use the special code 'nil' on the Z axis to disable it.
--In that case no Z values will be output at all while scribing.
--e.g scriberZ = nil
scriberX = 110
scriberY = 220
scriberZ = 0

--scriber axis. Leave this as nil if the scriber is fixed to the same axis as the torch
--scriberAxis = "A"
scriberAxis = "A"


--This an extra delay for the first pierce. The time is in seconds.
firstDelay=0

--************************************************
--*** End of settings ***
--************************************************