My X axis stopped working. I now have a ed light on the stepper driver board.
Would this mean he driver board is bad. Any test I can run to test it.
Thank You
red light on driver
2 posts
• Page 1 of 1
red light on driver
by Makingtoothpicks » Fri Oct 18, 2019 10:43 pm
-
Makingtoothpicks - Posts: 34
- Joined: Sun Sep 04, 2016 6:10 pm
- Location: Washington,USA
Re: red light on driver
by cncdrive » Fri Oct 18, 2019 11:02 pm
Well, it probably means a fault if it is red, but you should take a look at the stepper drive board users manual to make sure.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests