I don't have any plans to use it now, as I needed the 5LPT to work with the breakout board I'll be using.
If anyone wants an M44 motherboard, $25 delivered anywhere in the US.
M44 input question?
14 posts
• Page 2 of 2 • 1, 2
Re: M44 input question?
by ger21 » Fri Dec 09, 2016 12:25 pm
OK.
I don't have any plans to use it now, as I needed the 5LPT to work with the breakout board I'll be using.
If anyone wants an M44 motherboard, $25 delivered anywhere in the US.
I don't have any plans to use it now, as I needed the 5LPT to work with the breakout board I'll be using.
If anyone wants an M44 motherboard, $25 delivered anywhere in the US.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: M44 input question?
by bpratl » Fri Dec 09, 2016 4:11 pm
I also have a UC300ETH / M44B & C62 boards that I purchased to upgrade to UCCNC and have not yet finished the installation. Is the problem on all LP ports or just ports 4 & 5 or do I need to use the 5LPT board?
My plan was to the connect the C62 outputs directly to the stepper drivers if the M44B is compatible with UCCNC. Bob
My plan was to the connect the C62 outputs directly to the stepper drivers if the M44B is compatible with UCCNC. Bob
UC400ETH,W7 - lathe G0602
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
- bpratl
- Posts: 12
- Joined: Fri Jun 03, 2016 9:29 am
- Location: Gloucester, MA, USA
Re: M44 input question?
by ger21 » Fri Dec 09, 2016 4:30 pm
From what I've been told, the C62 should work fine with the M44 or M44B.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: M44 input question?
by bpratl » Sat Dec 10, 2016 10:47 am
Gerry, Thanks, now I have to find time to complete the upgrade. Bob
UC400ETH,W7 - lathe G0602
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
- bpratl
- Posts: 12
- Joined: Fri Jun 03, 2016 9:29 am
- Location: Gloucester, MA, USA
14 posts
• Page 2 of 2 • 1, 2
Return to Ask a question from support here
Who is online
Users browsing this forum: Fuellagoon and 20 guests