1.2112 screenset

[lp_felix]

i just want somting like this, 9*16 and not 16*9..

time to change the new screenset...

[cncdrive]

Cool, what holds you back Felix?

[lp_felix]

For now just time.. but i will change your 2019 screenset in a few days i hope..

[beefy]

And I want a diamond shaped screenset. Could you have it ready by next week, if not sooner

[cncdrive]

Sure Keith, just email me your billing info and we will start soon.

[NikolayUA24]

The problem was this line. Deleted and everything works.
//Add textfields to jog screen
AS3jog.Setfieldtext("10", 913);

[cncdrive]

Thank you. I will debug this line through the software soon to see why it would cause this problem.
I will post the results as soon as I will find something.

[NikolayUA24]

Profile chose UC100

[cncdrive]

Hi Nikolay,

Can you please test if you delete the slider from the jog screen and placing back that AS3jog.Setfieldtext("10", 913); then does it crash?
I would like to figure out if the slider causes this issue or the textfield itself.
It is unclear, because when the textfield gets the value that slider on the jog screen has the same labelnumber, so it also updates it's value.
And so far I do not see what could be the problem with that line of code, so it would help if you can tell me if it crashes without the slider, but with that Setfieldtext line put back in the screenset.

[thegreatwaldo]

Hi Balasz
While we are talking new scrensets, any chance of doing a full screen toolpath window like the original for those with smaller monitors or milk bottle (glasses) wearers.

cheers
Andrew