1.2112 screenset

[cncdrive]

Hmm, then I do not understand.
I mean what I now disabled all of those codes are now in try/catch for all exceptions. Which should never crash an application, because the try/catch handles all exceptions.
So, previously it crashed with only those try/catch bracketed codes enabled?! This is very very strange...

[markcadcam]

Yes, I have to click twice to close also.

[cncdrive]

Closing crash or whatever happens on closing is not a problem now.

[cncdrive]

What the problem is that I see no logical reason for the crash.
We narrowed down the crash to a single timer which code under that is now in try/catch for the generic Exception and a messageBox is there to show if an exception happens.
On your computers no exception happens, because there is no messagebox, but it crashes.
This is fully unlogical and I have no explanation for this and out of ideas.

[markcadcam]

No worries. I have to go away the rest of the evening and won't be able to test anything until tomorrow morning, if there is anything to test.

Mark

[NikolayUA24]

What the problem is that I see no logical reason for the crash.
We narrowed down the crash to a single timer which code under that is now in try/catch for the generic Exception and a messageBox is there to show if an exception happens.
On your computers no exception happens, because there is no messagebox, but it crashes.
This is fully unlogical and I have no explanation for this and out of ideas.

We helped as best we could, but the problem remained.

[cncdrive]

OK, checking through everything again, I see one more possibility.
Here is a new exe again, please check if it crashes or messagebox with text shown?

[markcadcam]

Crashes, no message box.

[cncdrive]

[cncdrive]

let me make a few test messageboxes in that code to see after which does it crashes at you.
We could probably narrow it down to a single line of code.