Hi Balazs,
would I be correct in assuming all system #vars would initialise to zero at system startup.
Also would it be bad programming practise to assume this, and should I have the Constructor Macro initialise any #vars I use to zero.
Keith
System #vars value at startup
3 posts
• Page 1 of 1
System #vars value at startup
by beefy » Fri Dec 09, 2016 7:27 am
- beefy
- Posts: 449
- Joined: Mon Sep 05, 2016 10:34 am
Re: System #vars value at startup
by cncdrive » Fri Dec 09, 2016 9:06 am
Hi Keith,
The UCCNC sets all #vars values to zero on startup.
The UCCNC sets all #vars values to zero on startup.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: System #vars value at startup
by beefy » Fri Dec 09, 2016 1:08 pm
Perfect, thanks Balazs.
That's what I was hoping for.
Keith
That's what I was hoping for.
Keith
- beefy
- Posts: 449
- Joined: Mon Sep 05, 2016 10:34 am
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 43 guests