I'm using the 2017 screenset and a uc100. I can't change the kernel frequency, I found another post about this issue and an update to solve it, but i'm using the latest screenset version (1 week old), so the update is not working for me. Any tip?
uccnc v1.2049
2017 screenset v1.06
uc100
2017 screenset problem
5 posts
• Page 1 of 1
2017 screenset problem
by dedebiv » Mon Aug 26, 2019 7:05 pm
- dedebiv
- Posts: 3
- Joined: Mon Aug 26, 2019 6:55 pm
Re: 2017 screenset problem
by ger21 » Mon Aug 26, 2019 10:53 pm
Did you copy all of the macros from UCCNC\Profiles\2017_Screenset_Macros into UCCNC\Profiles\macro_yourprofilename?
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: 2017 screenset problem
by dedebiv » Tue Aug 27, 2019 5:49 am
Yes. The 25 frequency is always selected: selecting both 50 or 100 make the corresponding checkbox flash briefly, but then it always get back to 25. Added a line to the m99998 beginning, sending a message to chek if it runs on startup, and it does.
- dedebiv
- Posts: 3
- Joined: Mon Aug 26, 2019 6:55 pm
Re: 2017 screenset problem
by ger21 » Tue Aug 27, 2019 10:47 am
Do all the other checkboxes work correctly?
It's working fine for me, and I've had no other reports of this issue.
It's working fine for me, and I've had no other reports of this issue.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: 2017 screenset problem
by dedebiv » Tue Aug 27, 2019 5:32 pm
Did a fresh new installation, now it’s working, thank you 
- dedebiv
- Posts: 3
- Joined: Mon Aug 26, 2019 6:55 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 15 guests