UC300ETH - Output Glitter

[Weerasak]

Dear All,

Some outputs are initialized during the reset button was clicked for the first time after Mach3 startup. I tested it with V1.020, V1.019, V1.015 all have the same issue.

Since UB1 has LED status on each input and output, So it's very easy to notice the glitter any output.

Does anyone have the same problem?

https://www.youtube.com/watch?v=dW6AYkH ... e=youtu.be

[cncdrive]

Hi Weerasak,

You already reported this issue to us in email and we working on it, no need to report it on the forum also...