restarting from middle of job

[BJB]

Wonder if anyone can help, i have a tool path that is going to take a good few hours to run, i was wondering if there is a way to restart and continue the tool path after i have shut down the system. I know that it remembers Zero so as long as i dont remove the piece thats ok. Apart from noting the line number i stop it at is there anther way.
Thanks

[dezsoe]

Of course, you can. Set the line number and press run from here. Then press cycle start.

[BJB]

Thanks, that what i thought. Didnt know if there was another way.
Thanks again