Automatic angle compensation possible?
11 posts
• Page 2 of 2 • 1, 2
Re: Automatic angle compensation possible?
by ger21 » Sun Jun 09, 2019 4:47 pm
It's in the latest test version of UCCNC.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
11 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 28 guests