forum.cncdrive.com

by **asuratman** » Tue May 07, 2019 3:37 am

things like these fillet, boring, taper, arc, groove, facing all work well, maybe only threading not working properly.

by **ger21** » Tue May 07, 2019 11:19 am

There is no lathe mode.

by **cncdrive** » Tue May 07, 2019 11:19 am

Threading works perfectly with the UCCNC if this was the question?!

by **asuratman** » Wed May 08, 2019 3:25 am

Thanks for reply, I will try it when I have AXBB-E ready.

by **asuratman** » Fri Feb 21, 2020 2:15 pm

Is there any plan for uccnc lathe in the near future ?

by **rodrigjup@gmail.com** » Sat Apr 16, 2022 10:58 am

Count me in !

by **BKG** » Wed Jul 20, 2022 10:57 am

Me to

by **spillage** » Fri Dec 30, 2022 4:21 am

Count me in as a prospective UCCNC Turn user.
I have a lath project somewhere in my future, and would prefer to stick with UCCNC than look at others like Acorn or Masso.

by **cncdrive** » Fri Dec 30, 2022 12:06 pm

UCCNC lathe version is basically finished with very good basically full featured lathe support with lathe screenset, lathe toolpath view, G95, G7/G8 and G96 support, we also added X tool offset to support lathes.
The next release will contain all these and we will continue working hard in January to release it asap.

by **markcadcam** » Sat Dec 31, 2022 6:54 pm

I'm looking forward to checking it out!

forum.cncdrive.com

Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Re: Put my name on the list for lathe users

Who is online