BUT this discusiion has gone way off track. IF you want to continue please use teh PMs to do so OR move back over to teh sheetcam forum OR CNCZONE to continue teh arguement.
Last Call
(;-) TP
Cutting a circle with a lead in perpendicular.
42 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Re: Cutting a circle with a lead in perpendicular.
by Vmax549 » Sun Apr 28, 2019 5:50 pm
I see teh relationship of teh 2 discussions(SheetCam and UCCNC). And I assume so do others.
BUT this discusiion has gone way off track. IF you want to continue please use teh PMs to do so OR move back over to teh sheetcam forum OR CNCZONE to continue teh arguement.
Last Call
(;-) TP
BUT this discusiion has gone way off track. IF you want to continue please use teh PMs to do so OR move back over to teh sheetcam forum OR CNCZONE to continue teh arguement.
Last Call
(;-) TP
- Vmax549
- Posts: 331
- Joined: Sun Nov 22, 2015 3:25 am
- Location: USA
42 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Who is online
Users browsing this forum: No registered users and 18 guests