Run from here bug

[Derek]

Version 1.2047

Institute a run from here, when the go to coordinate page comes up accidentally push your external "run" button instead of clicking on "OK".

UCCNC crashes then restarts. When it does all machine and work offset changes are lost.

[Vmax549]

Speaking of RFH. Has anyone else tried the RFH in G93 mode ??

Just a thought , (;-) TP

[dezsoe]

Version 1.2047

Institute a run from here, when the go to coordinate page comes up accidentally push your external "run" button instead of clicking on "OK".

UCCNC crashes then restarts. When it does all machine and work offset changes are lost.

It's a known issue and is fixed in 1.2106 test release.

[Derek]

It's a known issue and is fixed in 1.2106 test release.

Well I no longer run test releases since they are not properly tested, The last lockdown release of any merit was December 2017 which for motion control software with known issues is sort of lame if not outright dangerous. There has been so many bug fixes and added features to the test versions that I don't see how anyone has confidence actually running them. After nearly ruining a cylinder head by running a test version I rolled back to the lockdown. The development arc for UCCNC is like nothing I've ever seen.

Known bug since December 2017 and yet the lockdown version has not been updated. Why is that?