huanyang

[windows20]

is anyone using the hauanyang inverter with the axbb-e.if so can you help me set up please.

[cncdrive]

It should be simple to connect it. Just connect the analog output signal of the AXBB-E to the analog input of the VFD like how it is shown in the AXBB-E manual.
And connect a start signal and optionally a direction signal.
And configure your VFD to read the analog signal for spindle speed reference and to read the start signal from the screw terminals.
These can be set with some parameters of the VFD. The VFD manual describes them...

[windows20]

This is my problem I don't understand the manual at all.got the vfd settings all done,just don't understand what the wiring means.

[windows20]

ok if i put forward which is 24v to the 24v input and ground to pin 17 am i going about this the right way.

[ger21]

FWD and DCM should go to a relay. Have the AXBB toggle the relay with the M3 command.

[windows20]

Surely there must be a way of doing this without a relay

[windows20]

ok set up the relay so now i can turn it on and off.how do i connect to control the speed now.

[ger21]

It should be AO1 from the AXBB to VI on the HY.
5V on the AXBB to ACM on the HY.

Make sure the J1 jumper on the AXBB is removed for 0-10V.

[windows20]

thanks ger21 got it all set up but still cant controll speed from software.do i need to set pins in pwm and if so what numbers should i put in for them.

[windows20]

is there some thing i need to set for the analog output,not getting any voltage from there.