1.2109_Write Offset for Homing

[RWC]

Hi folks.
1.2109 Demo mode.
Configuration / Axis setup / Write Offset on Homing
The default download had X-0, Y-0, Z-2
I went to change the Z to 0 and it will not take. (hitting ENTER, of course).
I can enter any value other than 0 and it sticks in every axis but then trying to enter 0 in any of them, it reverts back to whatever the previous entry was. I now cannot get any axis Offset back to zero.
Is this a DEMO limitation ? or a possible BUG ?
Thanks for looking,
Russ

[ger21]

Works fine here, also in demo mode. Tried with UC100 Demo and AXBB demo.

[ger21]

FYI, you can disable the "ENTER" key requirement on the Appearance tab, if you so desire.

[RWC]

FYI, you can disable the "ENTER" key requirement on the Appearance tab, if you so desire.

Didn't notice that ..... (yet) THANKS !

Forgot to mention, AXBB her aas well.

Strange.
I'll try it with the ENTER disabled ... FWIW.
Thanks Gerry,
Russ

[ger21]

Are you clicking Apply Settings or Save Settings?

[RWC]

Yeah, I figured it out. Its a mini keyboard with the num pad overlying the qwerty keys.
With num lock on, 7,8,and 9 are the same but 0 is then an asterisk. Jeeeesh.
Turned the NUM LOCK off and its OK.
Thanks for taking the time Gerry, sorry.
Russ

[ger21]

I was going to say bad keyboard, but that was too easy, lol.